|
|||||||
| RX-7 3rd Gen Specific (1993-2002) RX-7 1993-2002 Discussion including performance modifications and Technical Support Sections. |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 3rd Gen Specific (1993-2002) RX-7 1993-2002 Discussion including performance modifications and Technical Support Sections. |
|
|
Thread Tools | Display Modes |
10-05-2009, 02:28 PM
|
#11 |
|
Rotary Fanatic
Join Date: Mar 2008
Location: Brenham, TX
Posts: 335
Rep Power: 18  |
I only drilled the center part of the nozzle for the water. I used about 4 drill bits and gradually went up in size. Did it all by hand cause they are so small i didnt want them to break off in the tip.i bought a set of like 10 bits. The largest size you need is just under 1mm. So if you get a set of 1 mm and under you should be good.
__________________
500+ HP thanks to:  Fast reacting IAT sensor thread! Mechanical Pre-turbo Water Injection Thread Dual Stock fuel pumps Thread T2 differential swap! |
|
|
| Bookmarks |
|
|
Threaded Mode