So TTT raised the issue of having sides and inclination for the dash. Well here's why I'm not concerned about it:
First you start with a regular dash surround.
Then you slowly cut out the dash pieces without damaging the surround:
Now take a trip to the fabric store and pick up some headliner and some glue. Once you have those make sure you get good measurements and trim to fit in some headliner:
You'll also need to do the top side. I chose to do this piece originally in two cuts, but for whatever reason the cut was too large so I had to trim it.
So, there you go. The start of the dash surround and the dash
I'm still waiting on the buttons, LED's, and Plexi glass. I will be finalizing the design of the dash soon enough, but I think even TTT will splooge on this dash (I still need to order the Fuel level gauge).