Go Back   Rotary Car Club > Tech Discussion > Fabrication

Fabrication Show off the parts that you've built from scratch or highly modified

Reply
 
Thread Tools Display Modes
Old 03-13-2011, 11:50 PM   #1
vex
RCC Loves Me Not You
 
vex's Avatar
 
Join Date: Jul 2008
Location: Influx.
Posts: 2,113
Rep Power: 20
vex will become famous soon enough
So TTT raised the issue of having sides and inclination for the dash. Well here's why I'm not concerned about it:

First you start with a regular dash surround.



Then you slowly cut out the dash pieces without damaging the surround:



Now take a trip to the fabric store and pick up some headliner and some glue. Once you have those make sure you get good measurements and trim to fit in some headliner:



You'll also need to do the top side. I chose to do this piece originally in two cuts, but for whatever reason the cut was too large so I had to trim it.



So, there you go. The start of the dash surround and the dash

I'm still waiting on the buttons, LED's, and Plexi glass. I will be finalizing the design of the dash soon enough, but I think even TTT will splooge on this dash (I still need to order the Fuel level gauge).
Attached Images
File Type: jpg IMG00199.jpg (94.2 KB, 45 views)
File Type: jpg IMG00200.jpg (110.1 KB, 45 views)
File Type: jpg IMG00201.jpg (67.4 KB, 45 views)
File Type: jpg IMG00202.jpg (80.1 KB, 45 views)
vex is offline   Reply With Quote
Reply

Bookmarks

Tags
dash, iq3, upholstery, vinyl wrapping


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:57 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com