[JustJeff]

Engine is mostly assembled. I have to check end play on the eccentric shaft. To do that I need to take the engine either to a friends shop or any shop that will use their air tools to torque down the flywheel nut so that I can test end play.

The other option is to research how to torque down that nut with a 150lb torque wrench and a big bar. I know it can be done but not sure what's involved with the whole process. If anyone can toss me some advice it'd be greatly appreciated.

In the mean time I was concerned about whether my turbo blanket would fit so I mocked things up to make sure I didn't have to make any changes. The blanket does touch the LIM and thats with only minimal torque on the nuts. I think it will work out just fine though. I put the UIM on for the hell of it.