Quote:
Originally Posted by RETed
Okay, "step wear" is defined by any gouge or valley *under* the measured surface.
I believe the FSM is specific to the areas - the most critical areas are at the 3 o'clock and 9 o'clock positions about 1" from the inner water jacket groove.
"Warpage" is defined by *any* deviation - whether is be "high" or "low" measured along a surface.
Technically, any "wear" (including the above "step wear") should not factor into this warpage inspection.
Warpage is to measure how much deflection out of parallel or perpendicular a surface is...usually across a broad area.
-Ted
|
Gotcha, thanks for clarifying Ted.
__________________
Quote:
|
Originally Posted by yzf-r1
Take your pathetic ultimatums and stupid "AOL" comments and shove them straight up your ass, you little punk. You avatar is gay as well....
|
1990 Vert/ S5-JDM 13BT (rebuilt but with issues I'm working out). Rtek N370 1.7, 550/800 injectors, FD fuel pump, RB REV TII exhaust, Tein springs and Illuminas
|