Thread: Why no fit?
View Single Post
Old 12-27-2013, 05:32 PM   #14
RETed
RCC Addict
 
Join Date: Mar 2008
Location: Honolulu, Hawaii USA
Posts: 1,813
Rep Power: 19
RETed will become famous soon enough
Quote:
Originally Posted by vrracing View Post
The only other factor I can think of here is the brake rotor thickness. It essentially acts like a spacer. In yall's experience do they vary much?
That's a good point...

I do run a set of prototype BBK Wilwoods up front, but they are maybe 1.0 - 1.5mm sunken in.
This is why I need to use spacers on my fronts, but I haven't mentioned them until now.

Now, I'm assuming that the wheels are fitting flush to the face of the hub - i.e. the area where the wheel studs come out of.
That should be consistent over all the FC models...?
Can you confirm if you brake rotors are flush with the hub face?
I would think even with aftermarket OEM replacement brake rotors, it should be pretty consistent and even...


-Ted
__________________
reted_2000@yahoo.com
Technical Advisor
FC3S Pro
http://fc3spro.com/



Quote:
Originally Posted by TitaniumTT View Post
because you're only as good as your backup
RETed is offline   Reply With Quote