Why no fit?

[RETed]

Originally Posted by vrracing

The only other factor I can think of here is the brake rotor thickness. It essentially acts like a spacer. In yall's experience do they vary much?

That's a good point...

I do run a set of prototype BBK Wilwoods up front, but they are maybe 1.0 - 1.5mm sunken in.
This is why I need to use spacers on my fronts, but I haven't mentioned them until now.

Now, I'm assuming that the wheels are fitting flush to the face of the hub - i.e. the area where the wheel studs come out of.
That should be consistent over all the FC models...?
Can you confirm if you brake rotors are flush with the hub face?
I would think even with aftermarket OEM replacement brake rotors, it should be pretty consistent and even...


-Ted