Quote:
Originally Posted by Barry Bordes
Cp1, how would you propose to fuse the new fins in? Could a piece of aluminum square tubing be used? (harder to machine two grooves but a lot more surface area!)
Barry
|
Sorry for the delay forgot which section this discussion was in and couldnt find it. but to answer your question i would just mill straight down the width of the housing, so longitudinally front to back if you would were looking at the motor built and in your car. i wouldnt add metal to the housing just take some away in logical places. ive been busy working on this for a little while so i should have something to show soon.
This weekend im going to the wrecker and ill see if i can grab some garbaged ones to use as an example.