45 dcoe help!

TheDriver216 · 04-15-2008, 08:25 PM

Well i installed a weber 45 dcoe from a forum member.. everything is hooked up.. problem is when i start it it it runs fine with the choke on.. 2k rpm steady no problems.. now when after i let it warm up and close the choke it accelerates up to about 3.5k rpm then comes crashing down and dies.. any ideas?.. i was told it ran before it was pulled off. new to weber carbs.. i havnt advanced my timing yet either ..

04-15-2008, 08:25 PM	#1
TheDriver216 Rotary Fanatic Join Date: Feb 2008 Location: Cleveland, Ohio Posts: 159 Rep Power: 18	45 dcoe help! Well i installed a weber 45 dcoe from a forum member.. everything is hooked up.. problem is when i start it it it runs fine with the choke on.. 2k rpm steady no problems.. now when after i let it warm up and close the choke it accelerates up to about 3.5k rpm then comes crashing down and dies.. any ideas?.. i was told it ran before it was pulled off. new to weber carbs.. i havnt advanced my timing yet either ..

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode