Project: "Last RX-7" by Herblenny

[Herblenny]

Originally Posted by rxspeed7

Looks amazing!!!! Although one question, how come you aren't running the oil line to the center bearings?

We didn't think about it when building this engine.. Maybe next time.

Aug. 15th, 2012 - This morning I decided to finish what I started yesterday... UIM and LIM.

To start, I took some of the cast marking off by filing them off.



After about 1-2 hours of this, I taped it up and sprayed with the same gray I been using, with high temp clear. I initially thought about doing wrinkle red, but after painting the short block, I think it might be bit off.



I let it cure over night and using a file, I took the clear and paint for the machined look, "3 ROTOR".



And to tie in the exterior of the car, I took one of the carbon fiber panel I had and made an insert. This took bit of time as I didn't have the right tools and used some sand paper and file to make the rectangle.




Next is TB and some of the accessories to match everything.. So, more pics in next couple of days.