My lexus v8 FB build

GySgtFrank · 02-14-2013, 12:08 AM

Their rear ends are probably setup to be used with their mounts. Which does you no good since you're a nonconformist.

Used to run into this a lot with lifted 4WD trucks when the u-joint angles got too severe the engine/trans mounts and pinion angles had to be changed. Your u-joint angles can't possibly fall into this category though.

The centerline from the eshaft to the back of the transmission output shaft has to be in the same plane as the pinion shaft. Is moving the front of the engine up or the back of the transmission down at all feasible?

A good guideline http://www.iedls.com/asp/admin/getFi...&TID=28&FN=PDF

Hope this helps, I really need to see this at Deals Gap.

02-14-2013, 12:08 AM	#11
GySgtFrank Professional Stick Poker Join Date: Feb 2011 Location: Stafford, Ks. Posts: 1,016 Rep Power: 16	Their rear ends are probably setup to be used with their mounts. Which does you no good since you're a nonconformist. Used to run into this a lot with lifted 4WD trucks when the u-joint angles got too severe the engine/trans mounts and pinion angles had to be changed. Your u-joint angles can't possibly fall into this category though. The centerline from the eshaft to the back of the transmission output shaft has to be in the same plane as the pinion shaft. Is moving the front of the engine up or the back of the transmission down at all feasible? A good guideline http://www.iedls.com/asp/admin/getFi...&TID=28&FN=PDF Hope this helps, I really need to see this at Deals Gap. __________________ 1988 N/A SE 2+2, dead stock and staying that way. 1979 SA22C stock? Not so much. http://rotarycarclub.com/rotary_foru...ad.php?t=15585

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode