|
|||||||
| Piston Engine Conversion Have you replaced your rotary with a V8 or any other type of piston engine? Tell us about it! |
 |
|
|
Thread Tools | Display Modes |
|
|||||||
| Piston Engine Conversion Have you replaced your rotary with a V8 or any other type of piston engine? Tell us about it! |
|
|
|
Thread Tools | Display Modes |
|
|
02-13-2013, 11:25 PM
|
#1 |
|
nerd
Join Date: May 2011
Location: Lakeland Florida
Posts: 107
Rep Power: 15  |
 a carefull look that i obviously failed to give it when i installed it will reveal the problem as i am seeing it, the car/trans are near as makes no difference level, and the rear is jacked up to all but ride height minus maybe 3/4" that the springs would let me get without lifting the car, this is an unaltered as ordered, bolt in grannies 8.8 rear end, and as i am seeing it, and the digi protractor i borrowed yesterday told me, the pinion is like 4 degrees UP instead of 1-3 degrees DOWN, it is as far as i can tell, totally wrong. and lowering the transmission for the 1uz install exacerbated the problem to the point it was noticed immediately |
|
|
|
| Bookmarks |
|
|
Hybrid Mode
