Go Back   Rotary Car Club > Tech Discussion > Show your rotary car build up.

Show your rotary car build up. Show off your Rotary Car build!

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 07-08-2008, 12:01 PM   #1
88turboii
destroy, rebuild, repeat
 
88turboii's Avatar
 
Join Date: Feb 2008
Location: Charleston, SC
Posts: 395
Rep Power: 18
88turboii is on a distinguished road
1988 Turbo II money pit

I bought it in Moorseville, NC for $3k..


picture that but with stock S4 TII wheels

It was sad condition, i probably paid too much. but it came with these mods:
Racing Beat 3" turbo back exhaust
K&N intake, 3" tid
Throttle body mod
Ported intake manifold
Emissions removed/simplified vacuum lines
S5 turbo
Blitz turbo timer
Rtek 1.7
SAFC II
720cc secondaries
Walbro 255 fuel pump
Greddy Type S BOV
ACT lightweight flywheel
ACT S/S clutch and HD PP

i fixed a bunch of small stuff, did all the regular maintainence, flushed all the fuilds, redline gear oil, etc

First thing was I swapped all the S5 exterior parts from my wrecked GXL, including S5 TII wheels. so it looked like this



then one night it got broken into, and the stereo, SAFC, and turbo timer all got ripped out.



and thats when i decided to do some upgrades..

20x9" ebay FMIC





Rtek 2.0



and installed new 750cc and 1000cc injectors from RC engineering and an AEM UEGO wideband o2

I had it dynod on this setup and it made 250whp, 6psi@redline



next, finally upgraded to a BNR stage 3 turbo, and a greddy profec II EBC



It was about this time, a coolant seal started to let go. still competely driveable, but i have to top of the coolant after every drive. Anway, i still took it to a dyno again to see what the BNR was at.. it made 307 whp with this setup, 12psi



It ran kinda lean up top, the rtek was maxed, and the injectors were at 90% duty cycle. I upgraded the 1000's to 1600's, but havent been back to the dyno since

Tein flex coilovers



and new slotted rotors/pads all around..



I also got a spare S4 TII engine rebuilt with a mild streetport



the latest mod is TII sideskirts and front lip





and thats how it is now.. Ive been thinking about ditching the rtek for a haltech, since staging the 1600s has been troublesome, so that is probably my next mod. I like the power where it is now, so i think most of the engine upgrades are done. Next up is body work and paint and swapping the new motor in

thanks for looking
__________________
1993 RX-7 Touring MB, stockport 13B-REW, 9.4CR rotors, T04S 60-1/p-trim single turbo
1986 RX-7 Base project track beast
88turboii is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:47 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com