|
|||||||
| Show your rotary car build up. Show off your Rotary Car build! |
|
|
Thread Tools | Display Modes |
|
|||||||
| Show your rotary car build up. Show off your Rotary Car build! |
|
|
Thread Tools | Display Modes |
09-02-2008, 05:56 PM
|
#11 |
|
Respecognize!
Join Date: Jul 2008
Location: Δx = ħ/2Δp
Posts: 3,190
Rep Power: 20  |
so one step back it seems. I dont think the intake manifold is sitting flush. Two different manifolds have done this...I think i need to just remove the two locators studs as they must be tweaked slightly to not allow the manifold to sit flush.
damn it Then the thermostat housing bolt broke off TIGHTENING it back in. damn it x2
__________________
For current updates and event coverage check out Follow on Twitter! @WhizbangRally Whizbang Rally's Webpage | Facebook |
|
|
| Bookmarks |
|
|
Threaded Mode