Go Back   Rotary Car Club > Tech Discussion > RX-7 2nd Gen Specific (1986-92)

RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections.

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 04-14-2011, 06:53 AM   #3
FRED
Rotary Fan in Training
 
Join Date: Mar 2011
Posts: 73
Rep Power: 15
FRED is on a distinguished road
There should be two HARDLINES clamped to the firewall going from the charcoal canister area to the area on the left side of the engine bay. One goes to the three way checkvalve back at the fuel tank and the other larger one goes to the crankcase vent line shown in your picture with the two fuel lines (ones with *radiator* clamps on them.

I'm not sure where the HOSE in your pictures is coming from. If coming from a hardline clamped to the firewall and that hardline is going over to the charcoal canister area, then that hose or a hose like it should go to the open hardline in your second picture.

See the jpg I attached earlier.

The hardline connected to nothing in your second picutre ...........if you follow it back to its original starting point on the engine, you'd find it gets tied to a nipple coming from the intermediate housing located just below the oil filler pipe. Real hard to see even when you know where it is when looking at a fully built up engine.

Last edited by FRED; 04-14-2011 at 06:58 AM.
FRED is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:50 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com