|
Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Don Mega
Join Date: Dec 2008
Location: Utopia
Posts: 1,688
Rep Power: 18 ![]() |
I remember we spoke about the idle in another thread last year, that can be an issue, but I have found it is system specific (though I have only used about 5 or 7 different CDI brands so can't comment on them all).
You are right, its a horses for courses question. If its down to money and the OP only wants 10psi then he would be mad to fit up a CDI system..... agree.
__________________
www.riceracing.com.au Worlds best Apex Seals Coil on Plug Water Injection ECU Calibration |
![]() |
![]() |
![]() |
#2 |
Rotary Fanatic
Join Date: Aug 2011
Location: crockett ca.
Posts: 176
Rep Power: 0 ![]() |
oh rr you type with angry fingers ,and in my words the word FUCK was not in the sentence .with that said ,topic stated 10 psi of boost ,so for application induction is the way ,in my dyno shop cdi is only needed for high boost .by reading all you have wrote very carefully i am not in a pissing match with you and appreciate what your Fact is ,but the heart of the matter is application is key,some products are valid for certain situations and when they are not needed its a waste of money. and what do the letters OP mean ?
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|