Waking up the FD, the rebuild of car and life

Oyvindjs · 04-25-2012, 11:55 AM

Drilled the holes extra large and added an extra sock for more insulation and making the whole thing stick really tight so it wont move around

Added some fuel and chemical resistant silicone to seal it properly

Also, cut open my front bottom cover earlier to make a cold air intake to my radiator. It scoops air from below the front lip, and straight to the radiator sitting in stock location, and from there, out through a vented seibon hood. Should be enough imo. I will also add some alu sheets to further guide the air.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-25-2012, 11:55 AM	#33
Oyvindjs Rotary Fan in Training Join Date: Apr 2012 Posts: 78 Rep Power: 14	Drilled the holes extra large and added an extra sock for more insulation and making the whole thing stick really tight so it wont move around Added some fuel and chemical resistant silicone to seal it properly Also, cut open my front bottom cover earlier to make a cold air intake to my radiator. It scoops air from below the front lip, and straight to the radiator sitting in stock location, and from there, out through a vented seibon hood. Should be enough imo. I will also add some alu sheets to further guide the air.