87 t2

[RETed]

There's specs to measure the depth of the bolt inside the pulley to tell if the bearing has slipped or not.
This is all shown in the FSM.


-Ted

[jahjahsqc]

Originally Posted by RETed

There's specs to measure the depth of the bolt inside the pulley to tell if the bearing has slipped or not.
This is all shown in the FSM.


-Ted

awesome!

I'll hunt through my manual later.

[jahjahsqc]

Originally Posted by RETed

There's specs to measure the depth of the bolt inside the pulley to tell if the bearing has slipped or not.
This is all shown in the FSM.


-Ted

So... just flipped through the entire engine section and tech info section. Didn't find it. Point me in a direction?

[chibikougan]

http://rotarycarclub.com/rotary_foru...ead.php?t=1790

[jahjahsqc]

Originally Posted by chibikougan

http://rotarycarclub.com/rotary_foru...ead.php?t=1790

Okay. I have in my hands a 1987 factory service manual. I don't see anywhere to check the depth of the bolt. What section is the bolt depth info in?

[Pete_89T2]

I have an '89 FSM, and found it in section C, page C-62. Assuming your '87 manual follows the same format, you'll find it in section C, but the page # and specs may be a little different - don't know myself. FYI, below is the content from the '89 FSM. Recommend you find same content in your '87 FSM and use those specs instead.

[jahjahsqc]

Originally Posted by Pete_89T2

I have an '89 FSM, and found it in section C, page C-62. Assuming your '87 manual follows the same format, you'll find it in section C, but the page # and specs may be a little different - don't know myself. FYI, below is the content from the '89 FSM. Recommend you find same content in your '87 FSM and use those specs instead.

awesome thanks!