20b Installs

j9fd3s · 02-22-2009, 03:45 PM

it would help to know where you are...

project would be pretty expensive, you need to buy a motor, fit it to the car, buy/fab the turbo manifold, buy the turbo and fuel system (injectors, pump), get an ecu that will run the thing, radiator, intercooler, oil cooler, clutch/flywheel/trans/driveshaft/rear end. then rebuild the engine, and tune everything.

plus labor....

it could easily be a $30,000 multi year project...

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-22-2009, 03:45 PM	#3
j9fd3s Rotary Fanatic Join Date: Mar 2008 Posts: 123 Rep Power: 18	it would help to know where you are... project would be pretty expensive, you need to buy a motor, fit it to the car, buy/fab the turbo manifold, buy the turbo and fuel system (injectors, pump), get an ecu that will run the thing, radiator, intercooler, oil cooler, clutch/flywheel/trans/driveshaft/rear end. then rebuild the engine, and tune everything. plus labor.... it could easily be a $30,000 multi year project...