Joff and MrsJoff's Chaste White BorgWarner FD build

[MrsJoff]

Well, since Jesse has been too busy working on the car, thought I would post some progress pictures. Jesse has taken the week off from work and we flew his Dad out for the week and they have been extremely busy on the car.

before:


now: test fitting the turbo


The cute little baby turbos are out and the rats nest is all over the ground. The garage is in a state of a somewhat organized chaos. I have a front bumper in my office, the living room couches are covered with body parts and you can not even walk into the spare bedroom since that has become the parts storage room. Hope this project does not take too long.


They are working on taking out the wire harness. All the wires that were under the UIM sound extremely crispy when you move them. Good thing that is being replaced.

Well, time for me to get to work. Need to wake up the boys, feed them and kick them back into the garage

[RCCAZ 1]

Originally Posted by MrsJoff

Well, since Jesse has been too busy working on the car, thought I would post some progress pictures. Jesse has taken the week off from work and we flew his Dad out for the week and they have been extremely busy on the car...

...The cute little baby turbos are out and the rats nest is all over the ground. The garage is in a state of a somewhat organized chaos. I have a front bumper in my office, the living room couches are covered with body parts and you can not even walk into the spare bedroom since that has become the parts storage room. Hope this project does not take too long.

You are SOooo funny. "Cute little baby turbos." Such a girlie comment As far as getting your house back anytime soon, let's see... Jill has been asking me that same question now for (hmmmm....) at least a couple of years now, but we're gettng closer. Tell Jesse (and his Dad) good luck with the build. Take a break and stop down to Intense for the show today (12/13) 11 am to 4 pm. Funny how when you start digging into these engines (FDs), you find out just how crispy everything has become.

[Force13b]

Originally Posted by joff

I really struggled to get this part off today for differential bushing replacement. I tried to do it without dropping the differential and disconnecting the PPF which may have been a bad move. It needed a small breaker bar to loose the 4 nuts holding this bracket to the top of the differential and there was just no room to get any leverage or length on the breaker bar.

[IMG]http://i660.photobucket.com/albums/uu325/JesseB0ff/rx7build003.jpg[/IM]

There is a pile of oily dirt underneath the car now in the garage from all the rummaging around I had to do get those nuts out. Between that and whats all over my hands, I figure I've shaved .1 second off my 0-60 just due to the weight reduction. :-) I had no idea it was going to be as messy a job as it ended up being.

sounds about the same from when i did my diff bushings