FC3S Murray's never ending build.

FC3S Murray · 04-01-2010, 11:28 AM

No worries Kyle, I wont be rodding it if this pressure doesnt go up.

I called mazdatrix and brianstormed with them. I did only put the teflon ring with halomar on the front cover casting, this is what Mazdatrix's rebuild video called for if you have the S5 type o-ring casting. They instructed leave the o-ring out.

Mazdatrix and I both agree this oil pressure problem is not a o-ring issue due to still getting higher pressure up in the higher rpm range BUT instead be a PUMP issue.

This figures since I swapped out the other pump from that last shit-ass motor that DID get 30 psi constantly at idle........that is what I get for visually comparing scars, BUT dammit this one I have in my motor is almost perfect.. ic ouldnt even catch a finger nail on any of the slightly visible valleys!

I mean seriously..I get upwards of 35-38 psi at 1400 rpm and it sky rockets as I climb in rpm.

What is the highest oil pressure value you guys get above 4K with the FD regulator @ normal oil operating temps? I am going to see what my highest value is once the motor is warm later today.

04-01-2010, 11:28 AM	#1
FC3S Murray frustrated! Join Date: Apr 2009 Location: Montana Posts: 611 Rep Power: 17	No worries Kyle, I wont be rodding it if this pressure doesnt go up. I called mazdatrix and brianstormed with them. I did only put the teflon ring with halomar on the front cover casting, this is what Mazdatrix's rebuild video called for if you have the S5 type o-ring casting. They instructed leave the o-ring out. Mazdatrix and I both agree this oil pressure problem is not a o-ring issue due to still getting higher pressure up in the higher rpm range BUT instead be a PUMP issue. This figures since I swapped out the other pump from that last shit-ass motor that DID get 30 psi constantly at idle........that is what I get for visually comparing scars, BUT dammit this one I have in my motor is almost perfect.. ic ouldnt even catch a finger nail on any of the slightly visible valleys! I mean seriously..I get upwards of 35-38 psi at 1400 rpm and it sky rockets as I climb in rpm. What is the highest oil pressure value you guys get above 4K with the FD regulator @ normal oil operating temps? I am going to see what my highest value is once the motor is warm later today. __________________ Same pig, new soul Last edited by FC3S Murray; 04-01-2010 at 08:57 PM.