Half bridge port on stock ecu.

N.RotaryTech · 06-02-2010, 06:58 PM

The bridge port could of been made bigger.
I only made it 1/8 inch. I should of made it 3/16 inch.

I probably will redo it over again sometime. Hopefully nothing will majorly blow up inside.
Bigger bridge port area. Maybe a full bridge. With new water seals, one piece apex seals, maybe solid corner seals. Etc.

Future plans?
Megasquirt, rebuild as mention above, turbo application.

06-02-2010, 06:58 PM	#11
N.RotaryTech Home-brew Rotary Join Date: Feb 2008 Location: GooseCreek SC Posts: 552 Rep Power: 18	The bridge port could of been made bigger. I only made it 1/8 inch. I should of made it 3/16 inch. I probably will redo it over again sometime. Hopefully nothing will majorly blow up inside. Bigger bridge port area. Maybe a full bridge. With new water seals, one piece apex seals, maybe solid corner seals. Etc. Future plans? Megasquirt, rebuild as mention above, turbo application.