How do they come apart?

speedjunkie · 10-21-2010, 01:07 AM

I got those fairly easily compared to what I'm hearing from you guys haha. Don't get me wrong, it's still a PITA to do, but not impossible. I ended up removing the three bolts that hold that panel in and pulling the panel down some, but I'm not sure it helped. You should be able to rotate those to another angle and maybe that would help. Also, since the push tab is virtually untouchable with your fingers you could use a flat tip screwdriver just to press the tab and then pull on the wires with your other hand. Or you could possibly use some needle nose pliers and squeeze the tab down (gripping each side of the connector) and then pull it out. Not sure. I've only done it once, and come to find out that harness wasn't the one that was bad LOL so we just plugged it right back in.

Rotary Related · 10-21-2010, 04:01 PM

It's a lot faster to unbolt the black brackets then pull it out a bit where you can get to it. The plugs can then be released from the brackets and finally unplugged from each other. Or take the blower out like someone already mentioned.

10-21-2010, 04:01 PM	#2
Rotary Related Good stuff at low prices Join Date: Oct 2010 Location: TX Posts: 52 Rep Power: 15	It's a lot faster to unbolt the black brackets then pull it out a bit where you can get to it. The plugs can then be released from the brackets and finally unplugged from each other. Or take the blower out like someone already mentioned. __________________ Visit us at: www.rotaryrelated.com or find us on facebook

10-21-2010, 01:07 AM	#1
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	I got those fairly easily compared to what I'm hearing from you guys haha. Don't get me wrong, it's still a PITA to do, but not impossible. I ended up removing the three bolts that hold that panel in and pulling the panel down some, but I'm not sure it helped. You should be able to rotate those to another angle and maybe that would help. Also, since the push tab is virtually untouchable with your fingers you could use a flat tip screwdriver just to press the tab and then pull on the wires with your other hand. Or you could possibly use some needle nose pliers and squeeze the tab down (gripping each side of the connector) and then pull it out. Not sure. I've only done it once, and come to find out that harness wasn't the one that was bad LOL so we just plugged it right back in.