|
|||||||
| RX-7 3rd Gen Specific (1993-2002) RX-7 1993-2002 Discussion including performance modifications and Technical Support Sections. |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 3rd Gen Specific (1993-2002) RX-7 1993-2002 Discussion including performance modifications and Technical Support Sections. |
|
|
Thread Tools | Display Modes |
11-23-2010, 09:12 AM
|
#2 |
|
RCC Contributor
Join Date: Mar 2008
Posts: 535
Rep Power: 18  |
THE 90 degree bends I have used are fairly long but when I needed a short 90 as the one on my sec turbo air intake pipe,used to replace the thin restriction at the turbo on the stock pipe, I used a CAST alum 90 elbow .It is 4 or 5 inches long and thicker than the other tubes so it is easy to weld .
|
|
|
| Bookmarks |
|
|
Threaded Mode