|
|||||||
| Show your rotary car build up. Show off your Rotary Car build! |
![]() |
|
|
Thread Tools | Display Modes |
|
|
|
|
#1 |
|
Don Mega
Join Date: Dec 2008
Location: Utopia
Posts: 1,688
Rep Power: 18 ![]() |
Well
![]() Fitted up the new waste gate springs yesterday bought option of 1.3 bar and 1.4 bar Tail springs (combination of different inner and outers). I settled on the lower 1.3bar combo just in case they gave a higher set boost. Along with the new higher power setting I upgraded the specification of the spark plugs and some other details too. Took the "beast" out for a drive today and the boost went to 1.53 to average of 1.50kg/cm! which is around 1.47 to 1.50bar! or old money 21+psi boost .......... it pulls like a mother fucker! First 3 2nd gear acceleration runs just torches the rear semi slick tires to 8000rpm, after about 6 or more passes and a few 3rd gear pulls the rear tires got very hot and sticky and could "almost" use all of the extra grunt in 2nd gear (only in straight line though and perfect road surface).... third gear is just stupid and is over in a couple of seconds, its very fast now.Fuel duty before was around 67% > now 75% same AFR Power on the Blitz was just under 300rwkw Peak fuel pressure was 70psi now its around 75psi EGT peaks have not gone above 890deg C First cool morning will go out and do a test of the 90-140kmh and also do a 100kmh to 200kmh acceleration test report along with VBOX power graph.
__________________
www.riceracing.com.au Worlds best Apex Seals Coil on Plug Water Injection ECU Calibration |
|
|
|
|
|
#2 |
|
Don Mega
Join Date: Dec 2008
Location: Utopia
Posts: 1,688
Rep Power: 18 ![]() |
305rwkw as measured by me ![]() Did a 90-140km 3rd gear test but battery went flat before all data could be written *I know excuses lol* covered the speed increment in 85m, previous best was 88m, off ECU data logging and given this distance its around 2.62 seconds which is Ferrari F40 beating territory. Boost on 3rd gear pull from 2500rpm 130kpa (18.9psi) ~ 4400rpm 145kpa (21psi) ~ 5000rpm holding to 8000rpm Turbo speed is 110,000+rpm now lol EGT fr 928 deg C rr 930 deg C peak. AFR 11.3:1 After the boost controller learned the new spring the power delivery is so violent in 2nd gear even with warm semi slicks it just throws the car sideways down the road and leaves two black lines on the road its sick ![]() From my best estimates its making around 490bhp to 500bhp at the engine corrected to std temp and pressure. Through a full catalyst equipped exhaust that is very quiet for road running *sounds nice at full power and revs* Engine has logged over 100 hours of use now at pretty high power settings, covered over 5000km testing. Hope to update with some nice VBOX graphs soon, though the weather here is shit at the moment, stupidly hot and monsoon conditions daily
__________________
www.riceracing.com.au Worlds best Apex Seals Coil on Plug Water Injection ECU Calibration |
|
|
|
|
|
#3 |
|
REIAN
Join Date: Feb 2008
Posts: 112
Rep Power: 18 ![]() |
Man your car is sick clean. Nice to see your putting the effort in getting your car tuned right. Can't wait to have my car put back together. Had it apart for painting....
__________________
1989 Turbo II. Track Car 1988 10thAE. Garage Queen 400+rwhp |
|
|
|
|
|
#4 |
|
The Newbie
Join Date: Jan 2010
Location: alhambra, CA
Posts: 8
Rep Power: 0 ![]() |
That is a impressive set up man. I have to agree, thats a nice air box you got there
|
|
|
|
![]() |
| Bookmarks |
|
|