|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
12-07-2010, 03:18 PM
|
#9 | |
|
RCC Addict
Join Date: Mar 2008
Location: Honolulu, Hawaii USA
Posts: 1,813
Rep Power: 19  |
Copper bearing wear with rounded edges like the top pic isn't that bad...
I worry about copper bearing wear with sharp cut-off's like the bottom pic. Guarans I would replace that... Since I'm replacing bearings, might as well replace them both, right? Only downside is that you gotta be extra careful on the break-in due to the new bearings. -Ted
__________________
reted_2000@yahoo.com Technical Advisor FC3S Pro http://fc3spro.com/ Quote:
|
|
|
|
| Bookmarks |
|
|
Threaded Mode