|
RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Mazda Lover
Join Date: Aug 2010
Location: Akron, Ohio
Posts: 319
Rep Power: 15 ![]() |
I say its not read by the transmission because while doing donuts (and spinning the rear wheels much faster than I was actually going) the speedometer isn't reading going any faster. Also, while going about 20mph through a parking lot, and pressing in the clutch and pulling the e-brake to lock the rear wheels, and effectively the transmission, the speedo still read my doing 20 at first and slowly decreasing to 0 when I had actually stopped.
That is what has me confused. I know my speedo is off by 5mph, but im not sure this is normal, or would be normal for a defective cable/worm gear
__________________
![]() 2004 Mazda6 V6 5-spd - still waiting on money for a motor 1991 Mazda RX7 NA 5-spd - my new DD with 145,000 miles |
![]() |
![]() |
![]() |
#2 |
RCC Addict
Join Date: Mar 2008
Location: Honolulu, Hawaii USA
Posts: 1,813
Rep Power: 19 ![]() |
Your speedo is fucked.
I run my car on the dyno (both DynoJet and DynaPack), and my stock speedo has no problem showing speed even though the vehicle is sitting in one place. -Ted |
![]() |
![]() |
![]() |
#3 | |
Waffles - hmmm good
Join Date: Aug 2008
Location: Huntersville, NC
Posts: 757
Rep Power: 0 ![]() |
Quote:
will still have at least one wheel turning and it will slow down gradually which is exactly what your seeing with the speedo.
__________________
1980 GS stockport, Fat Nikki, RB Dual Facetfuel pumps, Holley regulator, RB Street port exhaust, 2GDFIS, MR2 MK I electric fans, 2G strut bar, relayed fans, lights and fuel pump, LEDs Project Fat Nikki Budget 12A rebuild Video setup < $30.00 |
|
![]() |
![]() |
![]() |
Bookmarks |
|
|