Falcore

[speedjunkie]

I honestly don't remember too well, I replaced them about 5 or 6 years ago. I don't think I had too much of a problem other than getting the diff bushings in. Those were a PITA.

Wait, are you talking about reinstalling the upper arms onto the car or putting the bushings in the arm?

I didn't have too many problems with installing the bushings. I used sockets and a vise. When I tried to use the press on the rear lower arms I bent one of the arms. So I bent it back and then had it x-ray'd for cracks haha.

[Force13b]

Originally Posted by speedjunkie

I honestly don't remember too well, I replaced them about 5 or 6 years ago. I don't think I had too much of a problem other than getting the diff bushings in. Those were a PITA.

Wait, are you talking about reinstalling the upper arms onto the car or putting the bushings in the arm?

I didn't have too many problems with installing the bushings. I used sockets and a vise. When I tried to use the press on the rear lower arms I bent one of the arms. So I bent it back and then had it x-ray'd for cracks haha.

+1 to the diff bushings. I did those a couple years ago i used Noltec rear diff bushings.


Reinstalling them the bushings are in as you can see from the pic . I'll have to take a pic of what i'm talking about. I was hopping everything would just slide back in place so far that is not the case. Everything seems to fit tighter then a glove.