|
|||||||
| Fabrication Show off the parts that you've built from scratch or highly modified |
 |
|
|
Thread Tools | Display Modes |
|
|||||||
| Fabrication Show off the parts that you've built from scratch or highly modified |
|
|
|
Thread Tools | Display Modes |
|
|
03-03-2011, 02:38 PM
|
#1 |
|
RCC Loves Me Not You
Join Date: Jul 2008
Location: Influx.
Posts: 2,113
Rep Power: 20  |
Thanks I appreciate it. I think I may have made this overly complicated
 But what I have in my mind is going to be really nice, I even think I have an idea on how to angle it more. If you could get me a rough angle that would work well too.
__________________
The Official FC Radiator Thread My Project Thread: Cerberus CCVT Virginia Rotary Group |
|
|
|
03-03-2011, 02:50 PM
|
#2 | |
|
⊙⊙
Join Date: Dec 2009
Location: Great Falls
Posts: 1,258
Rep Power: 17 |
I like what your doing there. If you mount the LEDs in plexi be sure to torch the edges and back so all the light is forced through the Face. Just Torch enough to fog it not melt it. It should light up your turn signal arrows you have pictured really nicely and all you have to do is cut a cube of plexi and mount it to the back of the cutout. Mount LED inside the cube and you are good to go. If you don't want to see the LED you can mount it to the bottom of the cube so that it is a little lower then the arrow cutout so it should just make for a nice bright clean arrow.
__________________
Quote:
Last edited by chibikougan; 03-03-2011 at 02:54 PM. |
|
|
|
|
|
| Bookmarks |
| Tags |
| dash, iq3, upholstery, vinyl wrapping |
|
|
Hybrid Mode
