FC3S Murray's never ending build.

[FC3S Murray]

Originally Posted by RETed

Sorry, but I gotta say this...

The build started as a really costly build then turned into a V8 conversion.

I dunno why you went with the cheapie crush bent exhaust system, cause the necked-down bends are just hurting exhaust flow.


-Ted

I know I know but Kyle is right...no manderal bender anywhere. Not to mention the cost of labor I was gonna pay for using cut up peices of manderal bent pipe was gonna be upwards of 780.00(what he qouted me). The bends are not at all too severe, I will take a power hit to save the cash....I am a family man bro, money is very scarce when it comes to this car.

The entire car has been costly over the last 8 years lol, this swap was actually pretty cheap after all the money you rotary guys paid me for my old parts lol

in the v8's defense, i doubt it'll make any real difference lol

What I have read about a 3% decrease in power

[RETed]

Originally Posted by FC3S Murray

I know I know but Kyle is right...no manderal bender anywhere. Not to mention the cost of labor I was gonna pay for using cut up peices of manderal bent pipe was gonna be upwards of 780.00(what he qouted me). The bends are not at all too severe, I will take a power hit to save the cash....I am a family man bro, money is very scarce when it comes to this car.

Yeah, I hear yeah, and I've been sorta keeping up with this thread.
I know you've spent a LOT of money on the previous build, and I gotta hand it to you to get to this point.
Sorry to see you had to go through so much to get to this point.
I guess my point is that it's too bad you had to cut a little bit of corners to get it completed.


-Ted