who makes a good wideband?

[j9fd3s]

Originally Posted by sen2two

Does anyone have a problem with the actual Innovate set-up that dosnt involve the sensor?

Can you upgrade any one of the above listed "better" sensors to the Innovate set-up?

yes. mine likes to pop one of the capacitors on the board, they actually melt.

AFIK you have to use the bosch sensor (which is a slow POS, designed to go ON a slow POS), the calibrations are different.

IMO its kind of ok, cause i was totally falling into the "the wideband must read a certain number!" trap, instead of looking for how well the engine runs, or power....

for example i put the WB on the PP just to make sure it wasn't too lean, WB said mid 11's, which is much richer than the 13.2 everyone throws out, but the engine LOVED IT. plugs didn't look dark either...

oh and it does help that a weber IDA is fuel only, and its only got about a 5x5 map, with fixed rpm points and it just interpolates between cells