|
|||||||
| Show your rotary car build up. Show off your Rotary Car build! |
 |
|
|
Thread Tools | Display Modes |
|
|||||||
| Show your rotary car build up. Show off your Rotary Car build! |
|
|
|
Thread Tools | Display Modes |
|
|
05-05-2011, 08:43 AM
|
#1 | ||
|
Rotary Fanatic
Join Date: Mar 2008
Location: Rockville MD
Posts: 456
Rep Power: 18  |
Hey John as everyone said the car looks great in person. It was nice to meet you. Can't wait to see those Weds on there. It sucks that the powdercoater jerked you around. I loved the AD08's and stances on the dragon. Unbelievable grip. What settings were you running your dampers at on the dragon?
__________________
93 Frozen Grey Metallic FD Build thread here 17 Camaro SS 1LE 04 RX-8 GT Quote:
Quote:
|
||
|
|
|
05-05-2011, 06:11 PM
|
#2 | |
|
Rotary Fanatic
Join Date: Mar 2008
Posts: 142
Rep Power: 18 |
Quote:
^this. The AD08 and Stances were truly amazing. Exceeded my expectations by far. I have 12k F and 10k R spring rates. I had the dampers set at 9F 8R clicks from full soft. I had initially started the weekend a little softer, but bumped them up a bit to counter-act some rubbing in the front. It felt like the rear had a bit too much roll compared to the front, so I want to swap in a '93 sway bar (a bit stiffer than the 94's) to see how that helps.
__________________
Last edited by JhnRX7; 05-05-2011 at 06:17 PM. |
|
|
|
|
|
05-05-2011, 06:45 PM
|
#3 |
|
Rotary Fanatic
Join Date: Mar 2008
Location: Freedom Land
Posts: 316
Rep Power: 18 |
Did you design your own twin oil cooler installation? I don't see any expensive SS lines and AN fittings--bling bling that gets covered up anyway.
I like what you have done - if you made it do you mind sharing the what you did?
__________________
This is going to tear |
|
|
|
|
| Bookmarks |
| Tags |
| ducting, ducts, fd3s, jhnrx7, track |
|
|
Hybrid Mode
