Putting Tii skirts on a na or vert

JustJeff · 07-15-2011, 09:31 PM

Subscribed

I'm getting ready to prep and paint a few body parts for my vert...OEM skirts are some of those parts.

Pete_89T2 · 07-16-2011, 07:09 AM

To prevent rust from forming around drilled holes, I'd recommend a dabbing some POR-15 rust proof coating on the bare metal edges/local drilled hole area. You can get it online at www.por15.com

I've used this stuff before to restore a few rusty parts, such as some rust spots on my rear subframe, and to protect and put a hard coating on some critical wear areas on my car's underside - frame rails and hardpoints for jacks & jack stand were getting beat up by usage. The stuff is a bit expensive, but it works exceptionally well and you get what you pay for. For a small job like your holes, they have a starter kit for about $20 that has everything you'll need to clean/prep/coat a small area.

vrracing · 07-16-2011, 09:49 PM

That's a nice little kit. Ordered it. Thx

07-16-2011, 09:49 PM	#3
vrracing Rotating Assembly Join Date: Oct 2008 Location: TX Posts: 102 Rep Power: 18	That's a nice little kit. Ordered it. Thx __________________ 90 S5 Vert. JDM Tii with BNR Stage1 turbo. Pineapple Racing street port. Bonez cat-forward. Corksport cat-back with Vibrant UltraQuiet resonator. RTek 2 wZeitronix w/b. HKS EBC. Vis CF Tii hood. 3000GT wing. Ground Control coilover kit with KYB AGX shocks. Red and Black leather RX8 seats. Corksport Odura lip & bumper caps, OEM Tii skirts

07-16-2011, 07:09 AM	#2
Pete_89T2 Lifetime Rotorhead Join Date: Apr 2010 Location: Elkton, MD Posts: 874 Rep Power: 16	To prevent rust from forming around drilled holes, I'd recommend a dabbing some POR-15 rust proof coating on the bare metal edges/local drilled hole area. You can get it online at www.por15.com I've used this stuff before to restore a few rusty parts, such as some rust spots on my rear subframe, and to protect and put a hard coating on some critical wear areas on my car's underside - frame rails and hardpoints for jacks & jack stand were getting beat up by usage. The stuff is a bit expensive, but it works exceptionally well and you get what you pay for. For a small job like your holes, they have a starter kit for about $20 that has everything you'll need to clean/prep/coat a small area.