Mazdabaters peice of crap FC.

Mazdabater · 09-26-2011, 02:48 AM

Had a shitty setback this arvo, stayed back at work because I was going to bend some of the pipe up. 2 problems I have encountered, the minimum diameter I can bend my tube too is around 3" and my flaring tool requires me to have around a 45mm straight section to allow me to fit the feral on and flare it. So now I have to either

Make some of my pipes out of braided line with 90deg fittings
Buy a new flaring tool that requires less straight section to clamp
Find a way of bending the tube around a tighter radius

However I don't think its possible to have much smaller of a radius to bend the tube properly, going to do some research tonight.

09-26-2011, 02:48 AM	#11
Mazdabater FC3S Join Date: Jun 2010 Location: Townsville, QLD, AUS Posts: 326 Rep Power: 16	Had a shitty setback this arvo, stayed back at work because I was going to bend some of the pipe up. 2 problems I have encountered, the minimum diameter I can bend my tube too is around 3" and my flaring tool requires me to have around a 45mm straight section to allow me to fit the feral on and flare it. So now I have to either Make some of my pipes out of braided line with 90deg fittings Buy a new flaring tool that requires less straight section to clamp Find a way of bending the tube around a tighter radius However I don't think its possible to have much smaller of a radius to bend the tube properly, going to do some research tonight.