|
|||||||
| RX-7 1st Gen Specific (1979-85) RX-7 1979-85 Discussion including performance modifications and technical support sections |
 |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 1st Gen Specific (1979-85) RX-7 1979-85 Discussion including performance modifications and technical support sections |
|
|
|
Thread Tools | Display Modes |
|
|
11-28-2011, 12:28 PM
|
#1 |
|
I-had-a-bad-experience...
Join Date: Feb 2008
Location: M'boro
Posts: 1,046
Rep Power: 19  |
I'm not sure abotu the notch but if you are looking through the inspection cover on the exhaust side of the engine... when you line up the flat section of the flywheel parallel to the exhaust flange then the engine is at TDC. Your marks should be close to the pin. Should easily be able to determine bolt holes by then.
someone correct me if I am wrong.
__________________
 '15 Juke Nismo '06 MX-5 GT SOLD '04 S Silver RX-8 GT Track Day Use SOLD '90 Black TII vert w/ Sprint RE stock port/turbo DD dyno (242.6whp@5500rpm @12psi 8psi@redline) and (250ftlbtq@4800rpm @13psi) SOLD '89 GTUs 6p TII SOLD, '87 sport SOLD, '79 SA stock SOLD '91 B2600i 4x4 w/ Rx-8 LSD SOLD |
|
|
|
| Bookmarks |
|
|
Hybrid Mode
