|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
 |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
|
Thread Tools | Display Modes |
|
|
11-28-2011, 07:02 PM
|
#1 | |
|
RCC Addict
Join Date: Mar 2008
Location: Honolulu, Hawaii USA
Posts: 1,813
Rep Power: 19  |
Most of those Bosch units run a plastic cap at the tip.
I will remove them and leave them off. To seal the tip of the unit to the engine, I cut a length of 10mm (I.D.) silicone hose. You can use a section of 3/8" (I think that's the SAE equivalent to 10mm?) heater hose if 10mm vacuum hose isn't easily available. No need to worry about protecting the tip, since they are all protected in our engines. -Ted
__________________
reted_2000@yahoo.com Technical Advisor FC3S Pro http://fc3spro.com/ Quote:
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
