|
|||||||
| Ludwig Motorsports www.ludwigmotorsports.com (IN/KY) Full service; rotary engine builds, swaps, fabrication, etc. |
|
|
Thread Tools | Display Modes |
|
|||||||
| Ludwig Motorsports www.ludwigmotorsports.com (IN/KY) Full service; rotary engine builds, swaps, fabrication, etc. |
|
|
Thread Tools | Display Modes |
01-31-2012, 02:33 PM
|
#3 |
|
Rotary Masochist
Join Date: May 2008
Location: Floyds Knobs, IN
Posts: 494
Rep Power: 18  |
Working on it. Essentially, the story will be the same. Drop me a PM and I'll give you the basics on the heat shrink if you're ready to get started.
For connectors, we pretty much exclusively use the Deustch DT and DTM connectors. Here is a good run down on the DTMs. LINK For bulkhead connectors, there are a million different options.
__________________
_______________________________________________ One stop Haltech, AEM, Syvecs shopping. Installation and tuning. http://www.lms-efi.com Free support. Drop us an email. chris@lms-efi.com 502-515-7482 Facebook @LMS-EFI |
|
|
| Bookmarks |
|
|
Threaded Mode