82 gsl Diesel swapped

[12arotary]

Originally Posted by rotarycrazy

you should have put a triangle gusset in the corners to stiffen it up a bit plus it would make it stronger with all the TQ that a diesel puts out would be cheap insurance to make sure that the weld dont crack just my .02 cents there. Nice work other than that.

i was going to do that but the clearance is too close where the oil filter sits, so instead i did a square on the bottom outside (the reason the base overhangs an inch on each side- can't really see it in the pics, hoping it acts the same way but we shall see-