Norwegian S4 Base TII

RX-7FD3S · 04-13-2012, 08:20 AM

jævlar, har de prøvd å kjøre motoren på spillolje eller?

Pettersen · 04-14-2012, 10:26 AM

Pettersen · 04-15-2012, 08:29 AM

Fått gjort rotorne nesten helt ferdig, har også gått over side sealsene.

Checked the sideseals, and all except one was good. And that is propably the reason the front iron might be a throw away now...

Rotors looked good, except for one rotorface, wich had rusted and had lot's of pits. So i guess that is also a nice paperweight...

So far i probably need a new front iron, new sideseals and a new rotor.
Will buy a dial indicator and check the irons properly next week.

Pettersen · 05-01-2012, 01:30 PM

Got a bit bored today, so i drew up more or less how i plan to do the itb setup.
2*42mm for the periphial ports and 2*42mm for the side ports.

Pettersen · 05-12-2012, 01:23 PM

Made some ducting for the radiator, should help keep temps down.

04-13-2012, 08:20 AM	#1
RX-7FD3S Bartemann Join Date: Aug 2010 Location: Norway Posts: 22 Rep Power: 0	jævlar, har de prøvd å kjøre motoren på spillolje eller? __________________ 1992 Rx-7 Type R1 1978 mazda RX-4 WAGON antrasite/black edition carbody+fiberglass=boat Driving a LHD RX7 is like jerking of with your left hand. It can be done, but it just doesnt feel right the RX7`s: FB:financial burden FC: financial Crisis FD: financial disaste my rides: http://www.mazda-ogn.org/phpBB3/view...p?f=17&t=20083 http://www.mazda-ogn.org/phpBB3/view...hp?f=17&t=5233

04-14-2012, 10:26 AM	#2
Pettersen Rotary Fanatic Join Date: Mar 2010 Location: Norway Posts: 163 Rep Power: 16

04-15-2012, 08:29 AM	#3
Pettersen Rotary Fanatic Join Date: Mar 2010 Location: Norway Posts: 163 Rep Power: 16	Fått gjort rotorne nesten helt ferdig, har også gått over side sealsene. Checked the sideseals, and all except one was good. And that is propably the reason the front iron might be a throw away now... Rotors looked good, except for one rotorface, wich had rusted and had lot's of pits. So i guess that is also a nice paperweight... So far i probably need a new front iron, new sideseals and a new rotor. Will buy a dial indicator and check the irons properly next week.

05-01-2012, 01:30 PM	#4
Pettersen Rotary Fanatic Join Date: Mar 2010 Location: Norway Posts: 163 Rep Power: 16	Got a bit bored today, so i drew up more or less how i plan to do the itb setup. 242mm for the periphial ports and 242mm for the side ports.

05-12-2012, 01:23 PM	#5
Pettersen Rotary Fanatic Join Date: Mar 2010 Location: Norway Posts: 163 Rep Power: 16	Made some ducting for the radiator, should help keep temps down.