Norwegian S4 Base TII

Pettersen · 04-15-2012, 08:29 AM

Fått gjort rotorne nesten helt ferdig, har også gått over side sealsene.

Checked the sideseals, and all except one was good. And that is propably the reason the front iron might be a throw away now...

Rotors looked good, except for one rotorface, wich had rusted and had lot's of pits. So i guess that is also a nice paperweight...

So far i probably need a new front iron, new sideseals and a new rotor.
Will buy a dial indicator and check the irons properly next week.

Pettersen · 05-01-2012, 01:30 PM

Got a bit bored today, so i drew up more or less how i plan to do the itb setup.
2*42mm for the periphial ports and 2*42mm for the side ports.

Pettersen · 05-12-2012, 01:23 PM

Made some ducting for the radiator, should help keep temps down.

04-15-2012, 08:29 AM	#1
Pettersen Rotary Fanatic Join Date: Mar 2010 Location: Norway Posts: 163 Rep Power: 16	Fått gjort rotorne nesten helt ferdig, har også gått over side sealsene. Checked the sideseals, and all except one was good. And that is propably the reason the front iron might be a throw away now... Rotors looked good, except for one rotorface, wich had rusted and had lot's of pits. So i guess that is also a nice paperweight... So far i probably need a new front iron, new sideseals and a new rotor. Will buy a dial indicator and check the irons properly next week.

05-01-2012, 01:30 PM	#2
Pettersen Rotary Fanatic Join Date: Mar 2010 Location: Norway Posts: 163 Rep Power: 16	Got a bit bored today, so i drew up more or less how i plan to do the itb setup. 242mm for the periphial ports and 242mm for the side ports.

05-12-2012, 01:23 PM	#3
Pettersen Rotary Fanatic Join Date: Mar 2010 Location: Norway Posts: 163 Rep Power: 16	Made some ducting for the radiator, should help keep temps down.