3 Rotor FB build - "Silvie II" - Page 5

speedjunkie · 05-17-2012, 12:49 AM

I'm loving that touchscreen controller. I wish I was smart enough to make stuff like that lol.

ducktape · 07-12-2012, 10:31 PM

Should have posted these a while ago.

ducktape · 07-12-2012, 10:47 PM

So I designed a pair of offset ball-joints to correct the wheelbase after installing the 2nd gen crossmember. Here are some pics:

I could easily adapt this design to correct the roll-center on 2nd gen (without the rearward offset obviously). If anyone is interested, PM me.

MazdaMike · 07-19-2012, 09:33 PM

Great thread dude, love the dedication. I'm gonna do this to my FC someday.

07-19-2012, 09:33 PM	#64
MazdaMike S4 Owner Join Date: Jun 2008 Location: Tottenham, ON, Canada Posts: 48 Rep Power: 0	Great thread dude, love the dedication. I'm gonna do this to my FC someday. __________________ 1985 Mazda RX7 GSL 13B, Holley etc 1997 Mazda MX6 LS - DD lowered on 17s

05-17-2012, 12:49 AM	#61
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	I'm loving that touchscreen controller. I wish I was smart enough to make stuff like that lol.

07-12-2012, 10:31 PM	#62
ducktape Hardcore Join Date: Apr 2010 Location: Louisville, Ky Posts: 88 Rep Power: 16	Should have posted these a while ago.

07-12-2012, 10:47 PM	#63
ducktape Hardcore Join Date: Apr 2010 Location: Louisville, Ky Posts: 88 Rep Power: 16	So I designed a pair of offset ball-joints to correct the wheelbase after installing the 2nd gen crossmember. Here are some pics: I could easily adapt this design to correct the roll-center on 2nd gen (without the rearward offset obviously). If anyone is interested, PM me.