|
Show your rotary car build up. Show off your Rotary Car build! |
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Respecognize!
Join Date: Jul 2008
Location: Δx = ħ/2Δp
Posts: 3,190
Rep Power: 21 ![]() |
I need another FC in my life. Been heavily considering it for a track car.
whats the plan for this one?
__________________
For current updates and event coverage check out Follow on Twitter! @WhizbangRally Whizbang Rally's Webpage | Facebook |
![]() |
![]() |
![]() |
#2 | |
destroy, rebuild, repeat
Join Date: Feb 2008
Location: Charleston, SC
Posts: 395
Rep Power: 18 ![]() |
Quote:
i was going to assemble the front cover stuff yesterday, but i used a GSL-SE e-shaft and cant find the front bolt for it, ended up ordering one from mazdatrix, so will have to wait also, i found a haltech e6k.. so new plan is to try to run two ID2000 injectors and block off the secondaries. hopefully i can get it to idle and cruise on the 2000's and not have to deal with staging problems. the fuel system will be pretty simple with just a single rail, i will probably run an a1000 regulator, and a walbro 400. im going to try to keep the factory resistor relay for knocking down the voltage at low loads. Also going to run FC coils with bosch ignitor Last edited by 88turboii; 07-22-2013 at 07:20 AM. |
|
![]() |
![]() |
![]() |
#3 |
destroy, rebuild, repeat
Join Date: Feb 2008
Location: Charleston, SC
Posts: 395
Rep Power: 18 ![]() |
haha exactly
|
![]() |
![]() |
![]() |
Bookmarks |
|
|