|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
 |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
|
Thread Tools | Display Modes |
10-11-2013, 10:01 PM
|
#31 |
|
rotaryevolution.net
Join Date: Feb 2011
Location: Las Vegas, NV
Posts: 248
Rep Power: 15  |
no debate, use the turbo flywheel/CW for your series engine and the turbo clutch.
for the turbo driveshaft to mate to a non turbo differential though you would need the Turbo yoke swapped or use a dual flanged shaft to fit the n/a yoke. you will also need the turbo starter and clutch slave.
__________________
http://rotaryevolution.net |
|
|
|
10-12-2013, 08:17 AM
|
#32 |
|
IT'S ALIVE!
Join Date: Dec 2009
Location: Richmond, VA
Posts: 811
Rep Power: 16 |
The easiest way to run a TII transmission is to get the transmission, clutch, and flywheel from a TII. Then pickup the TII transmission-to-N/A rear end driveshaft Mazdatrix offers.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
