Go Back   Rotary Car Club > Tech Discussion > Rotary Tech - General Rotary Engine related tech section..

Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc...

Reply
 
Thread Tools Display Modes
Old 03-01-2014, 04:18 AM   #1
RICE RACING
Don Mega
 
RICE RACING's Avatar
 
Join Date: Dec 2008
Location: Utopia
Posts: 1,688
Rep Power: 18
RICE RACING will become famous soon enough
Quote:
Originally Posted by PSI View Post
Still only on 40psi boost but now with a larger BW turbo. As of last nights dyno session the car now has 640kw/858hp at the wheels vs the 740hp previously with the smaller turbo. Best trap speed with the smaller turbo was 158mph, 2400lb car. H pattern gearbox, 26x8 tyre, leaf sprung rear end.

I would have run up to 45psi on the dyno (map sensor limit) but the wastegate spring will only allow 40.5psi (280kpa). If the engine is still going when the season finishes I'll probably change w/g springs and see what it makes on 45psi, time permitting. I'm not holding out too much hope though, the engines done almost 2 seasons racing plus 2 powercruise events, dirt drags, and whatever else. I'm glad I didn't switch to E85 yet, pump petrol is starting to get real interesting now!
Good stuff, and YES I have always wondered why the fuck people accept the total head fuck of E85 when I proved (and you are now) water injection over so many years.................. beyond me!

Are you still using your IGN-1A coils? I have been given some special ones to test by a well known high performance manufacturer, and in the interests of science I may just use them myself.

Which BW did you move up to?

Peter
__________________
www.riceracing.com.au
Worlds best
Apex Seals
Coil on Plug
Water Injection
ECU Calibration
RICE RACING is offline   Reply With Quote
Old 03-01-2014, 10:37 AM   #2
TitaniumTT
Test Whore - Admin
 
TitaniumTT's Avatar
 
Join Date: Mar 2008
Location: Right Behind you son
Posts: 4,581
Rep Power: 10
TitaniumTT will become famous soon enough
Quote:
Originally Posted by PSI View Post
Still only on 40psi boost but now with a larger BW turbo. As of last nights dyno session the car now has 640kw/858hp at the wheels vs the 740hp previously with the smaller turbo. Best trap speed with the smaller turbo was 158mph, 2400lb car. H pattern gearbox, 26x8 tyre, leaf sprung rear end.

I would have run up to 45psi on the dyno (map sensor limit) but the wastegate spring will only allow 40.5psi (280kpa). If the engine is still going when the season finishes I'll probably change w/g springs and see what it makes on 45psi, time permitting. I'm not holding out too much hope though, the engines done almost 2 seasons racing plus 2 powercruise events, dirt drags, and whatever else. I'm glad I didn't switch to E85 yet, pump petrol is starting to get real interesting now!
That is just impressive as all get out. What ECU are you running and what size BW?

Quote:
Originally Posted by RICE RACING View Post
Good stuff, and YES I have always wondered why the fuck people accept the total head fuck of E85 when I proved (and you are now) water injection over so many years.................. beyond me!
But but but.... bdc?

Quote:
Originally Posted by RICE RACING View Post
Are you still using your IGN-1A coils? I have been given some special ones to test by a well known high performance manufacturer, and in the interests of science I may just use them myself.
Oh really? I FINALLY have in my possession the Bosch Motorsports Coils (I've actually been using them for a number of years now) along with the IGN-1A coils (running my RX8) and a set of factory D585 LS2 coils (thanks Glenn) Whenever the FC does make it onto the dyno after I get her tuned to about 12-14ish PSI I'm going to swap coils, adjust dwell and make a pull. Whichever coil makes the most power, is the setup that will stay on the car. I think it'll be between the IGN and the D585, and I have a feeling it will be the D585, although the IGN was designed around a 2-stroke Merc outboard soooooo, it should be interesting
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC

DEALS GAP!! WOOHOOOO!!!!!

2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!


I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact

Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @ Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-
TitaniumTT is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -5. The time now is 12:39 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com