Go Back   Rotary Car Club > Tech Discussion > Rotary Tech - General Rotary Engine related tech section..

Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc...

Reply
 
Thread Tools Display Modes
Old 03-25-2014, 12:13 PM   #1
jacobcartmill
Rotary Fan in Training
 
Join Date: Jun 2011
Posts: 50
Rep Power: 0
jacobcartmill is on a distinguished road
Ludwig, we were using the roller speed for RPM. in retrospect, i should have used the ignition pickup, but it is pretty close. my rev limiter is set at 7400, which is pretty close to where it cuts off on the graph.

and yes, i made sure the ramp rate was 160 for both turbo setups. (i went to a different dyno shop, so i had to use the ramp rate that the previous shop used to keep them the same).


also, i am just noticing how strange the dyno graph looks because the axes for torque and HP were different. i am going to check and see if i can get a graph with the same axes.

Last edited by jacobcartmill; 03-25-2014 at 12:21 PM.
jacobcartmill is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -5. The time now is 12:04 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com