|
Show your rotary car build up. Show off your Rotary Car build! |
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 | |
FUCK the fucking fuckers
Join Date: Mar 2008
Location: THE only Bay Area, Northern California
Posts: 3,172
Rep Power: 21 ![]() |
UPDATE: I went to work on the car today and it ran for a little bit.
It smoked a lot but after a few minutes the smoke stopped. WHOOHOO!!!! It wouldn't hold an Idle (bounced between 2500rpms and 200rpms) Efan won't turn on (it's an easy fix, i know which wire needs to be soldered) it made a little odd noise but I can't tell if it's the new filter and TID. There is no throttle response from the cabin. I plan on checking the timing, tps, throttle cable, and anything else I can think of over the next two days. I'm looking for a haltech installer so I can dump my car with them to get it done. ALSO: IF ANYONE HAS ANY TIPS, IDEAS, AND ANY WORDS OF WISDOM ON THE FOLLOWING: I noticed that the RB sway bar barely touches the Koyo lower radiator pipe. I'm concerned about this since it could potentially damage the radiator.
__________________
Quote:
![]() Last edited by Phoenix7; 06-09-2008 at 08:15 PM. |
|
![]() |
![]() |
![]() |
Bookmarks |
|
|