New project: 1976 Cosmo RX-5

[TitaniumTT]

Originally Posted by FC Zach

Originally Posted by FerociousP

Wait wait wait...

Originally Posted by FerociousP

tilt trans upward. wiggle some more. re align clutch disk if necessary (and make sure it fits on splines while you are at it)

Yeah.... the way we always did it was get a floor jack underneath the tranny to get the most clearance between the motor mounts and whatever subframe. An engine tilter/load leveler has always worked well for me. I've able to get my engine, bolted to the trans, installed singlehandedly.

http://www.summitracing.com/parts/trd-9099/overview/

Originally Posted by rx7 vinnie

You can stab it yourself...I do it all the time because I don't have dependable friends.

Werd.....

A few tips I've learned over the years that work across a variety of cars.

Engine tilters help for larger engines or trannies.... IE installing a Jeep tranny by yourself with a floor jack, helps get the proper angle on the engine.

Head to the hardware store and get a few long bolts the same thread as the tranny bolt. Cut the head off and thread them into the lower bolt holes on the block. If you have a stud extractor, proceed. If you don't have a stud extractor cut a notch into the open end of it so that you can unscrew them with a flat head screwdriver.

Line up the lower bolt holes on the tranny with the now studs on the engine. Get in the engine bay, grab onto the block, adjust yourself so nothing pointy is aimed at your manly bits and thrust with the grace of an overweight 40yo virgin. Once the dowels are in the bellhousing. Lower the tranny jack slightly, install one top tranny bolt, remove the lower "studs" and replace with tranny bolts one at a time.

This worked for me when trying to install my Jeeps tranny.... there's no real lower bolt holes, only on the top of the block....

Originally Posted by djmtsu

Tried that, no luck. Might need to readjust the chain, but it would be just as easy to have someone here to help.

Load Levels help but the reality is the rotary is so damn light and compact that if it starts level you can pretty much get it wherever you want it. I've been impatient before and not used the load leveler, instead took a piece of flat strapping and tied it to the engine pick point, then gone through one of the links on the chain to the picker, tied a butterfly knot in the flat strap (basically turning it into a 3:1 block) and pulled on it until at a better angle. See above about grabbing on and thrusting

Originally Posted by djmtsu

I'll get better pics when the engine is in, fenders are on, and the rear fuel tank and bumper are back on. There is still alot of weight not on the car, and the suspension hasn't been compressed yet.

DO IT NOAW!