Rice Racing M&W CDI COP Set-up

[RICE RACING]

You end up with some interference between the coil tabs in one orientation and in the other (offset) I'll need the bevel one edge of each coil spacer mount ..........

See what I can come up with, this way will clear as best it can and not interfere with heater coolant pipe as well, otherwise I would have spun it other way!

[RICE RACING]

And this way the coils smash into each other and there is ZERO room for a mount on the center plate...........

[RICE RACING]

Not possible to fit a proper mount in ~6mm space (plate + fastener).... well I would not feel good about it, I could recess something in not a worry I suppose, but add to that you will need to file down the tabs on the IGN-1A's as well as there is interference there too.