My RX7SP build up

speedjunkie · 01-07-2015, 12:47 PM

Quote:

Originally Posted by Fendamonky

Meh, that's like getting a Thoroughbred for racing but ONLY buying the bridle, because adding the saddle would take too much extra money...

Screw that! I'm not rich by any means, but half-assing a COP setup (from a consumers end) is just going to be more trouble than it's worth I think.

Fully agree. No way I'd get just the adapters, not when the brackets are that nice and well thought out. My buddy said he'd measure my setup for me, between the engine and water inj pump. I asked him to check on the PS and AC pump clearance too, but I figured someone else will probably get back to this before that.

RICE RACING · 01-12-2015, 04:04 AM

............

Slides · 01-13-2015, 02:52 AM

Will they match property retention of mazda on high temp heat cycling?

Quick thought, given that your chosen material would appear to have high strength and fracture toughness, for the high revving guys, if not running to as high boost, could you actually mill some of the weight out of the sides in the ends/ possibly even a strip along the guts to reduce the inertia of the seals for high rpm work to reduce chatter?

RICE RACING · 01-13-2015, 03:39 AM

...........

01-12-2015, 04:04 AM	#2
RICE RACING Don Mega Join Date: Dec 2008 Location: Utopia Posts: 1,688 Rep Power: 18	............ Last edited by RICE RACING; 08-01-2015 at 01:04 AM.

01-13-2015, 03:39 AM	#4
RICE RACING Don Mega Join Date: Dec 2008 Location: Utopia Posts: 1,688 Rep Power: 18	........... __________________ www.riceracing.com.au Worlds best Apex Seals Coil on Plug Water Injection ECU Calibration Last edited by RICE RACING; 08-01-2015 at 01:05 AM.

01-13-2015, 02:52 AM	#3
Slides Rotary Fan in Training Join Date: Apr 2012 Location: NSW, Australia Posts: 39 Rep Power: 0	Will they match property retention of mazda on high temp heat cycling? Quick thought, given that your chosen material would appear to have high strength and fracture toughness, for the high revving guys, if not running to as high boost, could you actually mill some of the weight out of the sides in the ends/ possibly even a strip along the guts to reduce the inertia of the seals for high rpm work to reduce chatter?