So im stuck at work. TII cranks, no tach. no firing.

Whizbang · 07-10-2008, 03:34 PM

did the coil just go bad? but even with that would one or the other get the engine

BURNIN_STREETS · 07-10-2008, 03:50 PM

Quote:

Originally Posted by Low Impedance

did the coil just go bad? but even with that would one or the other get the engine

Sounds like your TPS is dead. Check it according to the Heynes manual and let us know if its still good.

Phoenix7 · 07-10-2008, 04:03 PM

main relay still intact?

My5ABaby · 07-10-2008, 04:43 PM

Have you checked the fuses?

Quote:

Originally Posted by BURNIN_STREETS

Sounds like your TPS is dead. Check it according to the Heynes manual and let us know if its still good.

Well that's a load of shit. His car would still start with a dead TPS and it has nothing to do with the tach.

Whizbang · 07-11-2008, 08:25 AM

im worried that its in the harness. car started fine after i played around with a few connections....

it did this earlier this week as well but started, just had no tach. Then when you were going over 5 mph it has a two beep repeating noise going on the entire time you were driving...

TehMonkay · 07-11-2008, 10:21 AM

Quote:

Originally Posted by Low Impedance

im worried that its in the harness. car started fine after i played around with a few connections....

it did this earlier this week as well but started, just had no tach. Then when you were going over 5 mph it has a two beep repeating noise going on the entire time you were driving...

Because the power steering computer didnt know how fast the engine was spinning.

Whizbang · 07-11-2008, 11:01 AM

then how did it know i was stopped?

classicauto · 07-11-2008, 03:46 PM

To me it almost sounds like a crank sensor issue.

I'd check the wiring over and make sure there's no loose connections. Pay clsoe attention to the exposed wires where they enter the rubber grommet in the CAS, I've seen a few as of late with broken insulation there. No crank signal would certainly mean no start.

If the trailing coil was burnt, you'd have no tach, but it should still run it would just be a little sluggish and down on power. Although its a possibility, so you could swap another on since its simple and would rule out one option.

Phoenix7 · 07-11-2008, 03:49 PM

Quote:

Originally Posted by classicauto

To me it almost sounds like a crank sensor issue.

I'd check the wiring over and make sure there's no loose connections. Pay clsoe attention to the exposed wires where they enter the rubber grommet in the CAS, I've seen a few as of late with broken insulation there. No crank signal would certainly mean no start.

If the trailing coil was burnt, you'd have no tach, but it should still run it would just be a little sluggish and down on power. Although its a possibility, so you could swap another on since its simple and would rule out one option.

here is more info on the FC's Ignitions.

TehMonkay · 07-11-2008, 04:23 PM

Quote:

Originally Posted by Low Impedance

then how did it know i was stopped?

Electronic speed sensor in the speedometer.

07-10-2008, 03:34 PM	#1
Whizbang Respecognize! Join Date: Jul 2008 Location: Δx = ħ/2Δp Posts: 3,190 Rep Power: 20	So im stuck at work. TII cranks, no tach. no firing. did the coil just go bad? but even with that would one or the other get the engine __________________ For current updates and event coverage check out Follow on Twitter! @WhizbangRally Whizbang Rally's Webpage \| Facebook

07-11-2008, 08:25 AM	#5
Whizbang Respecognize! Join Date: Jul 2008 Location: Δx = ħ/2Δp Posts: 3,190 Rep Power: 20	im worried that its in the harness. car started fine after i played around with a few connections.... it did this earlier this week as well but started, just had no tach. Then when you were going over 5 mph it has a two beep repeating noise going on the entire time you were driving... __________________ For current updates and event coverage check out Follow on Twitter! @WhizbangRally Whizbang Rally's Webpage \| Facebook

07-11-2008, 11:01 AM	#7
Whizbang Respecognize! Join Date: Jul 2008 Location: Δx = ħ/2Δp Posts: 3,190 Rep Power: 20	then how did it know i was stopped? __________________ For current updates and event coverage check out Follow on Twitter! @WhizbangRally Whizbang Rally's Webpage \| Facebook

07-11-2008, 03:46 PM	#8
classicauto crash auto?fix auto Join Date: Feb 2008 Posts: 816 Rep Power: 18	To me it almost sounds like a crank sensor issue. I'd check the wiring over and make sure there's no loose connections. Pay clsoe attention to the exposed wires where they enter the rubber grommet in the CAS, I've seen a few as of late with broken insulation there. No crank signal would certainly mean no start. If the trailing coil was burnt, you'd have no tach, but it should still run it would just be a little sluggish and down on power. Although its a possibility, so you could swap another on since its simple and would rule out one option.